WRS805

WIRELESS TALKBACK SYSTEM

[Current Store(ja)][Selection Guide][System Diagram][Catalog]

Compact controller
High-speed response
Radio system not to be concerned about directivity
Generic relay contact outputs
1 button or 2 button transmitter
Easy installation

WRS805 is a system for performing talkback and CUE switch wirelessly in recording, post production, broadcast studio, etc.
By using the wireless method, operation that is conscious of obstacles like infrared remote control is unnecessary.

“Radio system”
Since WRS805 uses the Xbee radio system in the 2.4 GHz band, the response is fast and there is no need to operate while paying attention to directivity.
In addition, since the transmission signal is digitally modulated, it is rare to malfunction, but errors may occur due to the influence of the surrounding environment.
Since some mobile phones may be affected, please turn off the power in that case.

“Receiver”
The make contact output by the relay of the receiver makes interface with various equipment easy.
The standard is AC100V, but the working with a DC power supply supplied from COMMUNICATION connecter is possible.
Additionally, the combination with the external tarry is possible in the CUE lamp built-in model, too.

“Remote distance”
Although it is about 10 m, there may be differences depending on the installation environment of the receiver.
Please install it in a place that you can see to check the reception status by the LED on the front panel of the receiver. .

“Transmitter”
The simulcasting cannot possible, but can use multiple transmitters.
The command of the switch is not always transmitted, but it is turned on when pressed, and OFF command is transmitted when it is released.
If you lock it ON, press it again to initialize it.
Moreover, it is possible to use it for about one year because it goes to sleep mode when not in operation.

“Others”
If crosstalk seems to be a problem in adjacent studio etc., please contact us so we can change ID of transceiver.
Moreover, the receiver WRS805RXC with built-in CUE lamp is very convenient when using it permanently or when wiring is impossible.

This doc is applied to a product shipped after 2018.

■ Specifications
[TRANSMITTER]
•DIMENSIONS: 61Wx100Hx19D 100g
•CONTROL: 1 or 2 SWITCHES
•FREQ.: 2405~2480MHz, 5MHz step 16ch, IEEE 802.15.4, 1mW
•POWER: AAA size Alkaline or Lithium battery x2 , about 1 year
•MAX DISTANCE: APPROX.10m

[RECEIVER]
•DIMENSIONS: 110Wx46Hx140D 340g
•CONNECTOR: D-TYPE 9WAY MALE (#4-40)
•POWER: 100-120VAC 50/60Hz, DC +5~12VDC max 200mA
•OUTPUTS: RELAY CONTACT MAX 100mA

Current version is 3. You can download previous as follows.
WRS805_rev2
WRS805_rev1

       WRS805RX_rev3 "Communication " Dsub9-M(#4-40)
1 +V supply                     6 CUELP+(WRS805RXC)
2 CUELP-(WRS805RXC)             7 0V
3 contact common 1 (TB)         8 contact normal open 1 (TB)
4 contact common 2 (CUE)        9 contact normal open 2 (CUE)
5

           WRS805RX_rev1/2 "Communication " Dsub9-M(#4-40)
1 EXTERNAL DC INPUT +5 to +12VDC  6 EXTERNAL DC Common
2 contact common 1 (TB)           7 contact normal open 1 (TB)
3 contact normal close 1 (TB)     8 contact common 2 (CUE)
4 contact normal open 2 (CUE)     9 contact normal close 2 (CUE)
5

• Order Information

�