FU306

Super Fader (Single Fader)

[Current Store(ja)][Selection Guide][System Diagram][Catalog]

Stereo fader unit
100mm CP fader
XLR input and output
Buffer amplifier
Super high-quality sound, low noise
Compact

FU306 is the fader unit which is most suitable for level control without the sound quality deterioration.
It implements XLR connecter for input and output, and it is equipped with the amplifier circuit which is precision, and high common mode noise rejection ratio, and stable level control is possible and super low noise.

“Input and output”
The XLR connecter of the input and output promises a stable signal flow without the contact failure.

“Control”
In a fader unit of FU306, it adopts the 100mm stroke CP (conductive plastic) fader which is used in the large console, and with high reliability, operational feeling is better, and fine, smooth level control allows it.

“Buffer amplifier”
The balanced buffer amplifier of the input and output can avoid influence of the load impedance to be caused by a passive type and a problem of the high frequency attenuation in the long cable.
The parts of the buffer amplifier circuit of high quality provide clear sound without the coloring.
In addition, it can do the level fine adjustment in a trim of the rear panel.

“Scale”
The standard fader scale is 0dB at a full stroke position, but can change with a switch of the bottom panel in +10dB.

“Others”
Please choose FU302 in a left and right independence control fader type.
In addition, please refer about the manufacturing of the fader unit of any specifications.

■ Specifications
•INPUT CONNECTOR: XLR3-F, BALANCED, 20kΩ, HOT=2
•INPUT REFERENCE LEVEL: +4dBu, MAX=+24dBu
•OUTPUT CONNECTOR: XLR3-M, BALANCED, 50Ω, HOT=2
•OUTPUT REFERENCE LEVEL: +4dBu, MAX=+24dBu
•FADER UNIT: 100mm STROKE CONDUCTIVE PLASTIC FADER
•FREQUENCY RESPONSE: 20~20kHz ±0.1dB
•THD: <0.005% at 1kHz, at REFERENCE LEVEL
•NOISE: <-90dBu at REFERENCE LEVEL
•MAINS: 100-120VAC 50/60Hz, MAX 3W
•DIMENSIONS: 126Wx84Hx204D, 2kg

• Order Information

td>