PMS425

INCOM MIX

[Current Store(ja)] [Selection Guide][System Diagram][Catalog]

18ch income mixer
Connected directly with CCU550
High SN
Built-in compressor
5 programs
Private talk
ENG A, ENG B, 3 routes of PRD
19inches 6U size

PMS425 is the income mixer that a direct connection is possible to CCU550.
It is connectable with up to 18 cameras.
The income is ENG-A, ENG-B, 3 routes of PRD, and, as for the program, the monitor of 5 routes is possible.

“TX meter”
It can monitor the TX bus to a camera module when it chooses ENG-A, ENG-B, PRD.
These mix it and can indicate it.
When it chooses FLW of the master module, ENG-A, ENG-B, PRD are OFF and indicate the ENG of the camera module which chose FLW and an output mix signal of PRD.
The PGM indicates the PGM bus to a camera module and indicates the PGM output of the module when FLW is chosen at the same time.

“RX meter”
It indicates a signal same as the headset monitor of the master module.
It indicates each output which is sent from a camera module to the income system when it chooses ENG-A, ENG-B, PRD.
These mix it and can indicate it.
When it chooses FLW of the master module, ENG-A, ENG-B, PRD are OFF and indicate the ENG of the camera module which chose FLW and RX mix signal of PRD.

“Compressor”
In TX from an income system to a camera and RX from a camera to an income system, the communication that the clarity is high as for the variable possible compressor allows a threshold in the range of -8dBu to +15dBu.

“TB”
It outputs TB to each bus when it chooses ENG-A, ENG-B, PRD.
TB is sent to the camera module which chose FLW when it chooses FLW.
It can use 5 pin types for a headset, and the same signal is output by right and left.

“ENG-A, ENG-B, PRD ”
It chooses a group talking with ENG-A of the camera module, ENG-B, PRD switch.
When the LED detects the input from a camera, it turns red on in more than -15dBu.
When a switch is pushed, it turns on orange + yellow.

“TX, RX level”
As for the ENG of the camera module and TX and the RX level of PRD, ± 10dB variable is possible in a center click trim with it.

“LINK, FLW”
It mixes the signal of the PRD route of TX and RX to an ENG route with LINK switch.
Each signal of the PGM output, the ENG output, the PRD output, ENG input and the PRD input is sent to a master module when it presses FLW and mixes the TB from a headset to ENG, the PRD output.

“PGM”
It sets 5 program selection and output level.
Each PGM mixes it and is output, and, as for each output level, gain up of maximum +10dB is possible.

■ Specifications
•PGM, 4W INPUT: XLR3-F, 0dBu, BALANCED, 24kΩ
•4W OUTPUT: XLR3-M, 0dBu, BALANCED, 50Ω
•FREQUENCY RESPONSE: 20Hz-20kHz ±0.1dB
•THD: < 0.01% at 1kHz REFERENCE LEVEL
•NOISE: < -80dB
•TALLY INPUT: CONTACT or VOLTAGE, XLR3-F
•INCOM CONNECTOR: CCU550, D25-M (#4-40)
•MAINS: 100VAC 50/60Hz 80W(MAX)
•DIMENSIONS: 483Wx266Hx350D 10kg

       CCU D25-M(#4-40)
 1 ENG receive +      14 PRD receive + 
 2 ENG receive –      15 PRD receive – 
 3 GND                16 GND
 4 ENG send +         17 PRD send +
 5 END send –         18 PRD send -
 6 PGM send +         19 NC
 7 PGM send –         20 NC
 8 GND                21 NC
 9 NC                 22 NC
10 NC                 23 NC
11 R tally out X      24 G tally out X
12 R tally out Y      25 G tally out Y
13

• Order Information